To change the Transient voltage, use the numeric keypad and type the voltage.
Once you type in a number a shaded black box (■) will begin blinking
acknowledging the parameter is being changed. Press the Enter soft key to
accept the voltage, or press the Esc soft key to move back to the Trans-Volt
parameter screen. When the Enter soft key is pressed the voltage is accepted
and you transition into the next parameter: Trans-Site.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
*Parameter is only available if the Trans parameter is turned ON.
4.6.9 Editing Trans-Site* (PROGRAM Mode only)
Use the , soft keys to navigate to the Trans-Site parameter (only selectable
for AC output). Pressing the Edit soft key will provide the following screen:
Trans-Site = indicates the transient site that is programmed into the instrument.
Transient Site Range: indicates the transient site range that can be programmed
into the instrument.
To change the Transient site use the numeric keypad and type the time. Once
you type in a number a shaded black box (■) will begin blinking acknowledging
the parameter is being changed. Press the Enter soft key to accept the time, or
press the Esc soft key to move back to the Trans-Site Parameter screen. When
the Enter soft key is pressed the time is accepted and you transition into the next
parameter: Trans-Time.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
*Parameter is only available if the Transient parameter is turned ON.
To Next Page
Loading...
Need help?
General