pressed and the Memory Cycle is accepted, you transition into the next
parameter: Memory.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
4.6.3 Editing the Memory (PROGRAM Mode only)
Use the , soft keys to navigate to the Memory parameter. Pressing the Edit
soft key will provide the following screen:
Refer to section 4.3.1 for editing the Memory. If you wish to bypass editing this
parameter and move to the next parameter you can press the Prev or Next soft
key.
4.6.4 Editing the Step (PROGRAM Mode only)
Use the , soft keys to navigate to the Step parameter. Pressing the Edit soft
key will provide the following screen:
Step = indicates the step location within the memory.
Step Range: 1 – 9 indicates the step ranges available for selection.
To change the step, use the numeric keypad to select the step number and press
the Enter soft key to accept the step. To cancel the editing of the step number,
press the Esc soft key.
To Next Page
Loading...
Need help?
General