To change the ramp up time, use the numeric keypad and type the time. Once
you type in a number a shaded black box (■) will begin blinking acknowledging
the parameter is being changed. Press the Enter soft key to accept the time, or
press the Esc key to move back to the Ramp Up Time Parameter screen. When
the Enter soft key is pressed the time is accepted and you transition into the next
parameter: Timer Unit.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
4.6.13 Editing Timer Unit (PROGRAM Mode only)
Use the , soft keys to navigate to the Timer Unit parameter. Pressing the Edit
soft key will provide the following screen:
Timer Unit = indicates the timer unit mode that is programmed into the instrument.
Timer Unit Mode: indicates the timer unit mode that can be programmed into the
instrument.
The power up modes available are Second, Minute or Hour. Press the Change
soft key to toggle the timer unit mode to Second/Minute/Hour. To save the
parameter, press the Enter soft key. To cancel the editing of the Timer Unit Mode,
press the Esc soft key. When the Enter soft key is pressed the Timer Unit Mode
is accepted and you transition into the next parameter: Delay Time.
4.6.14 Editing Delay (PROGRAM Mode only)
Use the , soft keys to navigate to the Delay parameter. Pressing the Edit soft
key will provide the following screen:
To Next Page
Loading...
Need help?
General