Lock = indicates the security lock that is programmed into the instrument.
Lock Mode: indicates the lock mode that can be programmed into the instrument.
The Lock Modes available are ON and OFF. Press the Change soft key to toggle
the mode to ON or OFF. To save the parameter, press the Enter soft key. To
cancel the editing of the Lock Mode, press the Esc soft key. The level of security
is determined by the Mem Lock function. When the Enter soft key is pressed the
Lock Mode is accepted and you transition into the next system parameter: Mem
Lock.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
4.3.15 Editing Mem Lock
Use the , soft keys to navigate to the Mem Lock parameter. Pressing the Edit
soft key will provide the following screen:
Mem Lock = indicates the security lock that is programmed into the instrument.
Mem Lock Mode: indicates the lock mode that can be programmed into the
instrument.
The Mem Lock Modes available are ON and OFF. Press the Change soft key to
toggle the mode to ON or OFF. To save the parameter, press the Enter soft key.
To cancel the editing of the Mem Lock Mode, press the Esc soft key. The Mem
Lock parameter will only initiate if Lock Mode is set ON. When the Enter soft key
To Next Page
Loading...
Need help?
General