Page 10 Setup and Assembly Manual
Table of Pictures, part 2
Picture 31: Firmware Update ........................................................................................... 39
Picture 32: Summary of successful firmware update ....................................................... 40
Picture 33: Select ICC Profile .......................................................................................... 41
Picture 34: Scanner Profile status screen ........................................................................ 42
Picture 35: Printer ICC profile list ..................................................................................... 43
Picture 36: Content of printer ICC profile ......................................................................... 43
Picture 37: Upload new ICC profile .................................................................................. 44
Picture 38: List of options ................................................................................................ 45
Picture 39: Measurement methods .................................................................................. 46
Picture 40: Brightness Correction screen......................................................................... 47
Picture 41: Correction factor list ....................................................................................... 47
Picture 42: Arrows point on the hinges to be removed ..................................................... 48
Picture 43: Hexagon head screws to be removed ............................................................ 48
Picture 44: Lift and pull the device cover ......................................................................... 49
Picture 45: Arrows mark three of six alignment pins ........................................................ 49
Picture 46: Lifting the device cover in arrow direction ...................................................... 50
Picture 47:Separating device cover from device body ..................................................... 50
Picture 48: Disconnecting audio cable ............................................................................. 51
Picture 49: Disconnecting the signal cable ...................................................................... 51
Picture 50: Lifting the device cover .................................................................................. 52
Picture 51: Device cover in end position .......................................................................... 52
Picture 52: Setting the damping force of the hinge .......................................................... 53
Picture 53: Position of CSTT test target on the glass plate .............................................. 55
Picture 54: Position of IT8 test target on the glass plate .................................................. 56
Picture 55: Network Analyzer screen ............................................................................... 57
Picture 56: IP address for testing ..................................................................................... 58
Picture 57: Network Analyzer test result .......................................................................... 58
Picture 58: Recovery Key ................................................................................................ 59
Picture 59: Connectors on the WideTEK 25 ....................................................................
60
To Next Page
Loading...
Need help?
General
