Page 20 Setup and Assembly Manual
A.10.1 Connecting to the Network
Insert the network cable (delivered with the scanner) into the network cable connector
(Picture 7, #5). Connect the other side of the cable to a plug-in of an existing network.
Alternatively the scanner can be connected directly to a c omputer with network card by
using the crossover cable. In this case ensure that the network addresses used by the
computer and the scanner allow direct connection.
A.10.2 Connecting to the Power Source
Before connecting the scanner to the electrical outlet check the following items:
Ensure the electrical
outlet is in perfect condition and t hat it is
properly grounded.
Ensure that the electrical outlet is equipped with a fuse with the
proper capacity.
The electrical outlet must be near this device and must be easily
accessible.
Inspect the power cable and ensure that it is undamaged.
Use only the power cable delivered with the scanner.
Turn the device off before plugging or unplugging any cable.
To Next Page
Loading...
