Page 54 Setup and Assembly Manual
C.3 Cleaning the WideTEK 25 Scanner
Although the WideTEK 25 scanner is constructed with the focus on a minimum of cleaning
requirement, it is needful to clean some parts after a period of using.
C.3.1 Cleaning the Outside of the Glass Plate
It is recommended to clean the outside of the glass plate periodically to ensure constant
good scan results.
To clean the glass plate, lift up the glass cover. Use the microfiber cloth which is delivered
with the WideTEK 25 scanner or a fluff-free cloth.
Note: Because of the coating of the glass plate always use only a f ew drops of a
mild cleaning fluid with the microfiber cloth.
Moisten the microfiber cloth, then apply a few drops of a mild cleaning fluid and clean the
glass plate without pressing the cloth on it .
Use a soft cotton cloth to dry the glass plate after cleaning.
C.3.2 Cleaning the Inside of the Glass Plate
The inside of the glass plate should be cleaned in larger time periods.
To clean the inside it is necessary to remove the device cover from the device body. See
chapter C.1 for a detailed description of the necessary steps.
To clean the glass plate use the microfiber cloth which is delivered with the WideTEK 25
scanner or a fluff-free cloth.
Note: Because of the coating of the glass plate always use only a f ew drops of a
mild cleaning fluid with the microfiber cloth.
Moisten the microfiber cloth, then apply a few drops of a mild cleaning fluid and clean the
glass plate without pressing the cloth on it .
Use a soft cotton cloth to dry the glass plate after cleaning.
To Next Page
Loading...
