Implen NanoPhotometer NP80 User Manual

NanoPhotometer
®
N120/NP80/N60/N50/C40 User Manual Version 4.3.1
57
 File Server Access via USB cable
For file server access via USB cable connection, connect the NanoPhotometer
®
with a USB
A/B cable to the computer and open the Windows Explorer or Connect to Server option for
Mac (see file server access via LAN/WLAN) and enter \\192.168.7.1\ for connection.
 File Server Access via WiFi Hotspot
For file server access via WiFi Hotpot the WiFi Hotspot needs to be active on the
NanoPhotometer
®
. For activation see page 130 WLAN Settings. The computer needs to be
connected to the NanoPhotometer
®
WiFi Hotspot (SSID: NanoPhotometer
®
serial number;
password: Implenuser).
Open the Windows Explorer or Connect to Server option for Mac (see file server access via
LAN/WLAN) and enter \\192.168.8.1\ for connection.
BATTERY OPERATION
The optional battery operation is only available for the NanoPhotometer
®
N120/NP80/N60/C40 models (N120-Mobile, NP80-Mobile, N60-Mobile and C40-Mobile) and
not for the NanoPhotometer
®
N50. A full battery pack can be operated for approximately 8
hours (NP80/N60/C40) and 3 hours (N120) within normal usage, i.e. 20 - 30 measurements
per hour.
Note: Screen saver activation will influence the time for battery operation. To prolong battery
operation, switch the screen saver off.
When the battery gets low there will be a first warning message “Battery low” and a beep is
sounded. At this status it is possible to use the instrument under standard conditions for at
least one hour. It is recommended to charge the battery at this status. If the battery is not
charged there will be a second warning message when the battery is empty and several
beep sounds before the instrument is automatically shutting down within 10 to 15 seconds.
Note: Battery operation time is depending on display usage. Activating the screen saver
video may reduce the battery operation time.
Note: Unsaved data can be found in the auto save folder in Stored Results. If the
NanoPhotometer
®
is shut down during a measurement process the data of this
measurement are lost.
The battery pack is designed for 800 full charging cycles. Afterwards the capacity and
operation time of the battery may vary. A fully charged battery pack will self-discharge
(switched off NanoPhotometer
®
) over a time of 10 – 14 days. To avoid deep discharging of
the battery pack charge the battery pack at least once a month even if the NanoPhotometer
®
is not in use.
Note: Recharging of deep discharged batteries is not possible they need to be replaced by
new ones.
Charging time for an empty battery pack is 3 hours.

Implen NanoPhotometer NP80 Specifications

General

Brand	Implen
Model	NanoPhotometer NP80
Category	Measuring Instruments
Language	English