Implen OD600 - Self-Test; Important Error Messages

Implen OD600
®
User Manual Version 1.0
38
Self-test
The Implen OD600
®
Self-test is performed automatically every time the instrument is powered on. If the instrument
passes the self-test, the home screen will appear after a few seconds.
If the instrument does not pass the test, a window with the message explaining the reason for the failed test along
with the recommended solution will be shown. If the OK button is selected, the window is closed and the home
screen will be shown with an error message at the top. The error message is also shown on top of all other screen
and all performed measurements including the saved files of those measurements. If the self-calibration test fails
please contact the Implen Support Team.
7. Important Error Messages
Error
Information
Action
Err1
Blank Counts to High
'blank' counts to high. Please contact Implen Support. Err1
Err2
Blank Counts to Low
'blank' counts to low. Remove the obstacle in the light path! Otherwise
contact Implen Support. - Err2
Err3
Sample Counts to High
'sample' counts to high. Please contact Implen Support. - Err3
Err4
Sample Counts to Low
'sample' counts to low. Remove the obstacle in the light path!
Otherwise contact Implen Support. - err4
Err5
Hardware Fail
Hardware failed. Contact Implen Support. - Err5
Err6
General Measurement Error
Generic error! Please contact Implen Support. - Err6