Implen OD600 - Important Warning Messages

Implen OD600
®
User Manual Version 1.0
39
8. Important Warning messages
Error Types
Error Message
backup data usb failure
message
No USB device detected. Please connect a USB flash drive to the
USB port.
export data usb failure
message
No USB device detected. Please connect a USB flash drive to the
USB port.
battery charging error message
Battery cannot be charged. - [number]
battery critical message
Battery critically low. Please connect the charger.
battery full message
Battery fully charged. Please remove the charger.
Operational progress message
Please wait...
cal fail message
Calibration failed. A minimum of two standard points are required to
create calibration curve.
create logfile message
Please connect a USB flash drive to the USB port.
create logfile usb failure
message
No USB device detected. Please connect a USB flash drive to the
USB port.
Sntp no network message
No network connection. Automatic date and time synchronization not
possible.
factory reset final message
Are you certain you want to continue with resetting your OD600 device
to factory settings? All stored methods, settings and data will be
removed from the device.
factory reset primary message
Are you sure you want to reset the device to factory settings? Please
note that all stored methods and data will be lost and default values
restored.
firmware update inprogress
message
Please do not remove the USB device while the update is in progress.
firmware update usb failure
message
No USB flash drive detected. Please connect a USB flash drive with a
software update file to the USB port.
selftest generic message
Generic error! Please contact Implen Support. - [number]
selftest counts high message
Selftest failed, counts to high. Please contact Implen Support. -
[number]
selftest counts low message
Selftest failed, counts to low. Remove the obstacle in the light path!
Otherwise contact Implen Support. - [number]
language message
To apply the language changes, please restart the device.