Implen OD600 - Replacement Parts; Cleaning and General Care; De-Contamination Procedure; Warranty

Implen OD600
®
User Manual Version 1.0
42
Replacement Parts
 LED replacement
The Implen OD600
®
is equipped with a LED and should not need replacement until several years of use. In the
unlikely event the lamp does need to be replaced, this should be done by the manufacturer.
 Battery replacement
The battery can only be replaced by the manufacturer.
 Touchscreen/glass plate replacement
The touchscreen/glass plate can only be assembled or replaced by the manufacturer.
Cleaning and General Care
Switch off the Implen OD600
®
and disconnect the power cord prior to external cleaning. Use a soft wet cloth or dry
microfiber cloth to clean all external surfaces. A mild liquid detergent may be used to remove stubborn marks.
The instrument requires little maintenance, but the following are considered good practice:
1. Keep the instrument clean and dry. Wipe off any spilt liquids immediately. Clean with a slightly damp cloth; a
non-abrasive water-based soap or detergent may be used. The instrument may be wiped.
2. Remove the cuvettes from the instrument when not in use.
3. Store in a cool place away from corrosive chemicals or fumes.
Approved disinfectant solutions include: Apesin disinfection spray (Tana Chemi GmbH), Dr. Becher disinfection
spray (Dr. Becher GmbH), and Lysoformin Spezial (Lysoform Dr. Hans Roseman GmbH).
Optional: The cuvette shaft can be cleaned using a lightly damp cloth or a cotton swab.
Note: Observe all necessary precautions if dealing with hazardous samples or solvents.
De-contamination Procedure
To decontaminate we recommend that the instrument is wiped with ethanol or other antibacterial detergent as
required. The instrument can be sterilized using formaldehyde or ethylene oxide, but not with UV light (due to plastic
degradation). The cuvette shaft can be cleaned using a lightly damp cloth or cotton swap.
10. Warranty
Implen guarantees that the product supplied has been thoroughly tested to ensure that it meets its published
specification. The warranty included in the conditions of supply is valid for 24 months and is valid only if the product
has been used according to the instructions supplied. Implen or your supplier can accept no liability of loss or
damage arising from the faulty or incorrect use of this product.