20
2 Preparation
T Open the cover of the filler funnel for ground coffee.
‘Please add ground coffee’
T Place one level measuring spoon of ground coffee into the
filler funnel.
T Close the cover of the filler funnel.
‘Please select product’
T Press the ‘Espresso’ button.
Preparation starts.
‘Espresso’, the preset amount of water for
espresso flows into the cup.
Preparation stops automatically.
‘Please select product’
appears on the display.
It is easy to permanently adjust the amount of water for all single
products to the cup size. Adjust the amount once as shown in the
following example. Every time you prepare a drink in the future, this
amount will be dispensed.
Example: Proceed as follows to permanently set the amount of
water for one coffee.
Precondition:
‘Please select product’ is displayed.
T Place a cup under the coffee spout.
T Press and hold the
‘Coffee’ button until ‘Enough coffee?
Press button’
appears.
T Release the
‘Coffee’ button.
Preparation starts and the coffee flows into the cup.
E When adapting speciality coffees with milk, you are prompted
to open the switch l at this point. When there is enough milk
foam in the cup, close the switch again.
T Press any button as soon as there is sufficient coffee in the
cup.
Preparation stops.
‘Saved’ appears briefly on the display. The
set amount of water for one coffee is permanently stored.
‘Please select product’ appears on the display.
E You can alter this setting at any time by repeating the above
procedure.
Permanently setting the
amount of water for the
cup size
To Next Page
Loading...
