IMPRESSA F8 - Customizing Product Settings

26
4 Permanent settings in programming mode
In the programme item ‘Product settings’ (‘3/7’) you can make the
following settings:
U
‘Expert mode’
U
Set individual settings for all speciality coffees, milk and hot
water (see Chapter 4 ‘Permanent settings in programming
mode – Adjusting the product settings’).
U
Replace the products on the start screen with your favour-
ites (see Chapter 4 ‘Permanent settings in programming
mode – Replacing products on the start screen’).
U
Change the names of individual products (see Chapter 4
‘Permanent settings in programming mode – Renaming a
product’).
U
‘Factory setting’
U
Reset the set values for individual products to their factory
setting.
In the programme item
‘Product settings’ (‘3/7’) / ‘Expert mode’ you
can make individual settings for all speciality coffees and hot water.
The following permanent settings can be made:
Product Coffee strength Amount More settings
Ristretto,
Espresso,
Coffee,
Special coffee
; (mild),
;; (normal),
;;; (strong),
;;;; (extra-strong)
Amount of coffee:
25ml–240ml
Temperature (normal,
high),
product name
2 ristretti,
2 espressi,
2 coffees
– Amount of coffee: the
amount set for the single
product is doubled.
Temperature (as for single
product),
product name
Cappuccino,
Espresso
macchiato,
Latte macchiato
; (mild),
;; (normal),
;;; (strong),
;;;; (extra-strong)
Amount of coffee:
25ml–240ml
Milk foam:
0sec.–120sec.
Interval: 0sec.–120sec.
Temperature (normal,
high),
product name
Portion of milk
foam,
– Milk foam:
0sec.–120sec.
Product name
Hot water – Water: 25ml–450ml Temperature (low, normal,
high),
product name
Product settings
Adjusting the product
settings