IMPRESSA F8 - Changing the CLARIS Filter

39
5 Maintenance
T Insert the CLARIS Blue filter cartridge into the water tank,
exerting slight pressure.
T Close the filter holder. It will click into place audibly.
E After two months, the filter will cease to work. Set the date on
the date plate on the filter holder in the water tank.
T Fill the water tank with fresh, cold water and reinsert the
tank.
T Place a receptacle (at least 300 ml) under the fine foam
frother.
T Press the
‘Next’ button.
‘Switch open’
 l T Turn the switch to them position.
‘Filter is being rinsed’, water flows out of the fine foam
frother.
E You can interrupt rinsing of the filter at any time. To do this,
turn the switch clockwise. Turn the switch anticlockwise to
continue rinsing the filter.
E The water may be slightly discoloured. This is not harmful to
health and does not affect the taste.
Rinsing of the filter stops automatically after approximately
300ml.
‘Switch close’ appears on the display.
 y T Turn the switch to the °position.
‘Please select product’ appears on the display. The filter is
now activated.
E After 50 litres of water have flowed through, the filter will
cease to work. Your IMPRESSA will automatically prompt you
to change the filter.
E After two months, the filter will cease to work. Set the date on
the date plate on the filter holder in the water tank.
E If the CLARIS Blue filter cartridge is not activated in program-
ming mode, you will not be prompted to change the filter.
E CLARIS filter cartridges are available from specialised dealers.
Changing the filter