IMPRESSA F8 - Display Settings; Unit for Amount of Water

32
4 Permanent settings in programming mode
 g T Turn the Rotary Switch to adjust the water hardness.
T Press the
‘Save’ button.
‘Saved’ appears briefly on the display.
‘Maintenance settings’
 O T Press the P button to exit programming mode.
‘Please select product’
In the programme item ‘Machine settings’ (‘5/7’) / ‘Display’ you can
set the display brightness and contrast (as a percentage).
Precondition:
‘Please select product’ is displayed.
 O T Press the P button.
‘Maintenance status’ (‘1/7’)
 g T Turn the Rotary Switch until
‘Machine settings’ (‘5/7’) is dis-
played.
T Press the
‘Display’ button.
‘Display’
 g T Turn the Rotary Switch to change the display setting.
T Press the
‘Save’ button.
‘Saved’ appears briefly on the display.
‘Machine settings’
 O T Press the P button to exit programming mode.
‘Please select product’
In the programme item ‘Machine settings’ (‘5/7’) / ‘Units’ you can
select the unit used for the amount of water.
Example:Proceed as follows to change the unit for the amount of
water from
‘ml’ to ‘oz’.
Precondition:
‘Please select product’ is displayed.
 O T Press the P button.
‘Maintenance status’ (‘1/7’)
 g T Turn the Rotary Switch until
‘Machine settings’ (‘5/7’) is dis-
played.
T Press the
‘Units’ button.
‘Units’
T Press the ‘oz’ button.
Display settings
Unit for amount of water