27
4 Permanent settings in programming mode
Permanent settings in programming mode always follow the same
model.
Example:Proceed as follows to change the coffee strength for one
coffee from ‘ normal ’ (;;) to ‘strong’ (;;;).
Precondition:
‘Please select product’ is displayed.
O T Press the P button.
‘Maintenance status’ (‘1/7’)
g T Turn the Rotary Switch until
‘Product settings’ (‘3/7’) is dis-
played.
T Press the
‘Expert mode’ button.
‘Expert mode’
E Next select the button of the product for which you would like
to make settings. No product is prepared at this point.
T Press the
‘ > ’ button (bottom right) until ‘Coffee’ is dis-
played.
T Press the
‘Coffee’ button.
‘Coffee’
T Press the ‘Coffee strength’ button.
‘Coffee’ / ‘Coffee strength’
g T Turn the Rotary Switch to change the coffee strength set-
ting.
T Press the
‘Save’ button.
‘Saved’ appears briefly on the display.
‘Coffee’
O T Press the P button to exit programming mode.
‘Please select product’
You have the option of replacing the four products on the start
screen with your personal favourites.
Example:Proceed as follows to replace
‘Cappuccino’ on the start
screen with
‘Macchiato’.
Precondition:
‘Please select product’ is displayed.
O T Press the P button.
‘Maintenance status’ (‘1/7’)
g T Turn the Rotary Switch until
‘Product settings’ (‘3/7’) is dis-
played.
Replacing products on
the start screen
To Next Page
Loading...
