IMPRESSA F8 - Setting Water Hardness

31
4 Permanent settings in programming mode
U
‘Switch-on rinse’
U
‘Manual’: The switch-on rinse must be started manually.
U
‘Automatic’: The switch-on rinse is started automatically.
Example: Proceed as follows to specify that the switch-on rinse
should be started manually.
Precondition:
‘Please select product’ is displayed.
 O T Press the P button.
‘Maintenance status’ (‘1/7’)
 g T Turn the Rotary Switch until
‘Maintenance settings’ (‘6/7’) is
displayed.
T Press the
‘Switch-on rinse’ button.
‘Switch-on rinse’
T Press the ‘Manual’ button.
T Press the
‘Save’ button.
‘Saved’ appears briefly on the display.
‘Maintenance settings’
 O T Press the P button to exit programming mode.
‘Please select product’
E If you are using the CLARIS Blue filter cartridge and have acti-
vated it, it is not possible to set the water hardness.
The harder the water is, the more frequently the IMPRESSA needs to
be descaled. It is therefore important to set the water hardness accu-
rately.
The water hardness can be adjusted on a continuous scale between
1 °dH and 30 °dH.
Precondition:
‘Please select product’ is displayed.
 O T Press the P button.
‘Maintenance status’ (‘1/7’)
 g T Turn the Rotary Switch until
‘Maintenance settings’ (‘6/7’) is
displayed.
T Press the
‘Water hardness’ button.
‘Water hardness’
Setting the water
hardness