25
4 Permanent settings in programming mode
4 Permanent settings in programming mode
Press the P button to enter programming mode. You can navigate
through the programme items and permanently save the required
settings simply by turning the Rotary Switch and using the multi-
function buttons. The following settings can be made:
Programme item Sub-item Explanation
‘Maintenance status’
(
‘1/7’ and ‘2/7’)
‘Clean’,
‘Change the filter’ (only
if filter is activated),
‘Descale’ (only if filter is
not activated),
‘Cappuccino cleaning’,
‘Rinse the coffee
system’
,
‘Rinse the milk system’
T Start the required maintenance pro-
gramme here.
‘Product settings’ (‘3/7’) ‘Expert mode’,
‘Factory setting’
T Select your settings for speciality coffees
and hot water.
T Reset the settings for single products to
their factory setting.
‘Machine settings’
(
‘4/7’)
‘Choose language’,
‘Switch off after’,
‘Save energy’,
‘Factory setting’
T Select your language.
T Set the time after which the IMPRESSA
should switch off automatically.
T Select an energy-saving mode.
T Reset the machine to its factory setting.
‘Machine settings’
(
‘5/7’)
‘Units’,
‘Display’
T Select the unit for the amount of water.
T Change the display settings.
‘Maintenance settings’
(
‘6/7’)
‘Use filter’,
‘Water hardness’ (only
if filter is not activated),
‘Switch-on rinse’
T Indicate whether you are operating your
IMPRESSA with or without a CLARIS Blue
filter cartridge.
T Adjust the water hardness.
T Change the settings for switch-on rinse.
‘Information’ (‘7/7’) ‘Product counter’,
‘Maintenance counter’,
‘Version’
T Keep track of all products prepared and
view the number of maintenance pro-
grammes performed and the maintenance
status.
To Next Page
Loading...
