IMPRESSA F8 - Dismantling the Fine Foam Frother

37
5 Maintenance
T Immerse the milk pipe in the receptacle.
T Place a receptacle under the fine foam frother.
T Press the
‘Next’ button.
‘Cappuccino cleaning’
As soon as the machine has heated up, ‘Switch open’
appears.
 l T Turn the switch to them position.
‘Cleaning Cappuccino’ appears and the fine foam frother
and the milk pipe are cleaned.
‘Switch close’
 y T Turn the switch to the °position.
‘Water for Cappuccino’
T Rinse the receptacle thoroughly, fill it with 250ml of fresh
water and immerse the milk pipe in the water.
T Empty the other receptacle and place it under the fine foam
frother once more.
T Press the
‘Next’ button.
‘Switch open’
 l T Turn the switch to them position.
‘Cleaning Cappuccino’, the fine foam frother and the milk
pipe are rinsed with fresh water.
‘Switch close’
 y T Turn the switch to the °position.
‘Please select product’ appears on the display.
To make sure the fine foam frother works properly, and in the inter-
ests of hygiene, it must be dismantled and rinsed daily if you have
been preparing milk. Your IMPRESSA will not prompt you to disman-
tle and rinse the frother.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Carefully remove the fine foam frother from the Connector
System
©
by twisting slightly.
Dismantling and rinsing
the fine foam frother