IMPRESSA F8 - Factory Reset and Language Selection

33
4 Permanent settings in programming mode
T Press the ‘Save’ button.
‘Saved’ appears briefly on the display.
‘Machine settings’
 O T Press the P button to exit programming mode.
‘Please select product’
In the programme item ‘Machine settings’ (‘4/7’) / ‘Factory setting’
the machine can be reset to its factory setting: All user settings
(apart from the ‘filter’ and ‘water hardness’) are reset to factory set-
tings. Your IMPRESSA then switches off.
Precondition:
‘Please select product’ is displayed.
 O T Press the P button.
‘Maintenance status’ (‘1/7’)
 g T Turn the Rotary Switch until
‘Machine settings’ (‘4/7’) is dis-
played.
T Press the
‘Factory setting’ button.
‘Factory setting’ / ‘Reset the machine to the factory set-
tings?’
T Press the ‘Yes’ button.
‘Saved’ appears briefly on the display.
Your IMPRESSA is switched off.
In this programme item you can set the language used by your
IMPRESSA.
Example:Proceed as follows to change the language from
‘English’
to
‘Deutsch’.
Precondition:
‘Please select product’ is displayed.
 O T Press the P button.
‘Maintenance status’ (‘1/7’)
 g T Turn the Rotary Switch until
‘Machine settings’ (‘4/7’) is dis-
played.
T Press the
‘Choose language’ button.
‘Choose language’
E To display more languages, press the ‘ > ’ button (bottom
right).
Restore factory settings
Language