IMPRESSA F8 - Maintenance Settings Configuration

30
4 Permanent settings in programming mode
In the programme item ‘Machine settings’ (‘4/7’) / ‘Save energy’ you
can permanently set an energy-saving mode (Energy Save Mode,
E.S.M.
©
):
U
‘Active’
U
Soon after the last preparation, the IMPRESSA stops heating
up. After about 5 minutes the message
‘Energy Save’ is dis-
played.
U
Before you can prepare a speciality coffee, speciality coffee
with milk, or hot water, the machine must heat up.
U
‘Inactive’
U
All speciality coffees, speciality coffees with milk and hot
water can be prepared without having to wait.
Example: Proceed as follows to change the energy-saving mode
from
‘Active’ to ‘Inactive’.
Precondition:
‘Please select product’ is displayed.
 O T Press the P button.
‘Maintenance status’ (‘1/7’)
 g T Turn the Rotary Switch until
‘Machine settings’ (‘4/7’) is dis-
played.
T Press the
‘Save energy’ button.
‘Save energy’
T Press the ‘Inactive’ button.
T Press the
‘Save’ button.
‘Saved’ appears briefly on the display.
‘Machine settings’
 O T Press the P button to exit programming mode.
‘Please select product’
In the programme item ‘Maintenance settings’ (‘6/7’) you can make
the following settings:
U
‘Use filter’
U
Activate the CLARIS Blue filter cartridge (see Chapter 5
‘Maintenance – Inserting and activating the filter’).
U
‘Water hardness’ (only if filter is not activated)
U
If you do not have a filter cartridge, you will need to set the
water hardness (see Chapter 4 ‘Permanent settings in pro-
gramming mode – Setting the water hardness’).
Energy-saving mode
Maintenance settings