IMPRESSA F8 - Descaling Process Steps

43
5 Maintenance
T Empty the drip tray and coffee grounds container and put
them back into the machine.
‘Agent in tank’
T Remove and empty the water tank.
T Completely dissolve the contents of one blister (3JURA des-
caling tablets) in a receptacle holding 500ml of lukewarm
water. This may take several minutes.
T Pour the solution into the empty water tank and insert it into
the machine.
‘Switch open’
T Carefully remove the fine foam frother from the Connector
System
©
by twisting slightly.
T Place a receptacle (at least 500ml) under the Connector Sys-
tem
©
.
 l T Turn the switch to them position.
‘Machine is being descaled’, water flows out of the Connec-
tor System
©
several times.
The operation is interrupted,
‘Switch close’.
 y T Turn the switch to the °position.
‘Machine is being descaled’, the descaling operation is con-
tinued.
The operation is interrupted,
‘Empty drip tray’.
T Empty the drip tray and coffee grounds container and put
them back into the machine.
‘Fill water tank.’
T Empty the receptacle and place it under the Connector Sys-
tem
©
and the coffee spout.
T Remove the water tank and rinse it thoroughly.
T Fill the water tank with fresh, cold water and reinsert the
tank.
‘Switch open’
 l T Turn the switch to them position.
‘Machine is being descaled’, the descaling operation is con-
tinued.
The operation is interrupted,
‘Switch close’.