Communication Ports Setup Page 21 - 5
21
COMM PORT 2 Menu (Continued... )
DELIVERY (Report Deliveries to:)
DELIVERY DIAL STRING
blank
up to 4 numbers
ALARMS (Report Alarms to:)
ALARM DIAL STRING
blank
up to 4 numbers
LEAKS (Report Tank Leaks to:)
LEAK DIAL STRING
blank
up to 4 numbers
LINES (Report Line Leaks to:)
LINE DIAL STRING
blank
up to 4 numbers
— Press the
DOWN
▼ key to show more menu items —
SCALD (Report SCALD Tank Leaks to:)
SCALD DIAL STRING
blank
up to 4 numbers
SECURITY (Input a security code to limit access to the Tank Sentinel
SECURITY CODE console data base ...highly recommended)
blank
up to 6 characters
DATA MODE Menu
Use the DATA MODE – internal Tank Sentinel
modem – for remote connection to IBM PCs.
Go back / display these menus (at left) and
press
M3
and then
M1
to access Data
Mode.
DATA MODE
MODE Press
M1
key.
COMMUNICATIONS MODE
NATIVE
Use
UP/DOWN
▲
▼ keys to show choices.
VEEDER ROOT Press
ENTER
to accept this data.
—
CONTINUED
ON
THE
NEXT
PAG E
—
NOTE
☞
Cycle console power on and off
after programming is done, or after
any COM PORTS setting is
changed. Also, when the data / fax
modem is present, press
CHECK
&
M3
DIALTONE to see if a dial tone
is detected.
___ Dial Strings
reference sets of
remote access
and phone
numbers
(NUMBERS 1 thru
4) that are
programmed in the
AUTODIAL menu.
For example:
Input a 1 2 to
automatically call
and send data to
phone numbers 1
and 2.
FAX/MODEM
*
DATA MD
FAX MODE
*
M1 M2 M3 M4
COMM PORTS
COMM 1 COMM 2
FAX/MODEM
*
M1 M2 M3 M4
To Next Page
Loading...
Need help?
General
