21
Page 21 - 8 Tank Sentinel Setup Programming Guide
FAX MODE Menu
Use the optional internal fax/modem to send
reports to remote Fax machines.
Go back / display this menu (at left) and
press
M3
and
M2
to access these menus.
FAX MODE Automatically FAX up to 4 numbers when
AUTODIAL Deliveries, Alarms, Reports, Line Tests
FAX AUTODIAL or Leak Test occur
NUMBER 1
NUMBER 2
NUMBER 3
NUMBER 4
(N = number 1, 2, 3, or 4)
FAX NUMBERS N
ACCESS CD (Use the Access Code field when
ACCESS CODE N phone number is longer than 12
characters - see example)
blank
12 characters
Use keypad to input access code.
Press
ENTER
to accept this data.
PHONE NUM (Input a FAX phone number)
PHONE NUMBER N
blank
12 characters
(if more than 12 characters - see example)
Use keypad to input FAX number.
Press
ENTER
to accept this data.
(Fax/Modem retries several times when busy)
—
CONTINUED
ON
THE
NEXT
PAG E
—
COMM PORTS
COMM 1 COMM 2
FAX/MODEM
*
M1 M2 M3 M4
FAX/MODEM*
DATA MD
FAX MODE
*
M1 M2 M3 M4
ACCESS CODE or PHONE No. AT Command Characters:
D = (
,
) comma = Dial Delay
Example —
88DD88DD912072830156
(20 character phone number)
‘Switching code’=
88
Dial Delays=
DD
“to dial out”=
9
“long distance”=
1
Access Code:
88DD88DD91
(10) Phone Number:
2072830156
(10)
Cycle console power on and off after
programming is done, or after any COM
PORTS setting is changed. Also, when the
data / fax modem is present, press
CHECK
&
M3
DIALTONE to see if a dial
tone is detected.
NOTE
☞
To Next Page
Loading...
Need help?
General
