TS-TPI Setup Programming Page 23 - 11
23
— RESERVE Group N Menu continued —
Use the keypad to enter a percent value for each group.
Press the
ENTER
key to accept data entry.
This entry returns the display to the GROUP N menu, displaying TYPE, MODE and RESERVE.
Press the
CANCEL
key to return to the TPI GROUP menu, displaying GROUP 1 to GROUP 4.
Proceed to the next group number menu.
Repeat the steps above to set the reserve percent for each group that is in Priority Mode.
When setup programming is completed, follow the Exiting Setup Mode steps (next) to return the Tank
Sentinel back to the Run Mode.
Exiting Setup Mode
EXIT SETUP (user entry)
Press the
CANCEL
key to return to the main TPI menu, which displays ENABLE, PUMP and
GROUP.
This completes the Setup Programming for the TPI device.
Press the
CANCEL
key to return to the TPI SETUP MENU menu, which displays TPI.
Press the
CANCEL
key to return to the main SETUP MENU menu, which displays EXIT, SYSTEM,
TANKS and PROBES.
Press the
M1
key under the word EXIT to return the Tank Sentinel to RUN MODE.
To Next Page
Loading...
Need help?
General
