1
Page 1 - 2 Tank Sentinel Setup Programming Guide
S
YSTEM
Menu (C
ONTINUED
...
FROM
PREVIOUS
PAG E
)
SYSTEM ID
(enter new 5 line report header, see below)
Default Report Header Ø
LINE 1
LOCATION LINE 1
INCON
enter up to 24 characters max.
Press
ENTER
to accept this data.
LINE 2
LOCATION LINE 2
INTELLIGENT CONTROLS
enter up to 24 characters max.
Press
ENTER
to accept this data.
LINE 3
LOCATION LINE 3
P. O. BOX 638
enter up to 24 characters max.
Press
ENTER
to accept this data.
LINE 4
LOCATION LINE 4
SACO ME 04072
enter up to 24 characters max.
Press
ENTER
to accept this data.
LINE 5
LOCATION LINE 5
1-800-984-6266
enter up to 24 characters max.
Press
ENTER
to accept this data.
UNITS
(Units are set in either US Standard or Metric)
MEASUREMENT UNITS
VOLUME
(– change if not using the default US units)
VOLUME UNITS
(volume measurement units)
GALLONS
Use
UP/DOWN
▲
▼ keys to choose units.
LITERS
Press
ENTER
to accept this data.
LEVEL
(– change if not using the default US units)
LEVEL UNITS
(level and length units)
INCHES
Use
UP/DOWN
▲
▼ keys to choose.
CM
(Metric - Centimeters)
Press
ENTER
to accept this data.
TEMP
(– change if not using the default US units)
TEMPERATURE UNITS
(Prints F for Fahrenheit, or C for Celsius on reports)
FAHRENHEIT
Use
UP/DOWN
▲
▼ keys to choose units.
CELSIUS
Press
ENTER
to accept this data.
NO. TANKS
(enter total number of tanks in the system)
NUMBER OF TANKS
1
enter number of tanks.
Press
ENTER
to accept this data.
............... LINE 1
:
:
:
..... LINE 5
To Next Page
Loading...
Need help?
General
