2
Page 2 - 2 Tank Sentinel Setup Programming Guide
Tanks – TANK DATA N Menu (C
ONTINUED
...
FROM
PREVIOUS
PA GE
)
N refers to / represents a tank number
NAME (Use SHIFT to change from A-M to N-Z to NUMERIC.)
TANK NAME N
TANK N
enter up to 7 characters max.
Press
ENTER
to accept this data.
(INCON recommends leaving the tank name as TANK N )
MANIFOLD
MANIFOLD FOR TANK N (selct only when tanks are part of a manifold)
NONE
MANIFOLD 1
Use
UP/DOWN
▲
▼ keys to display Manifold 1 thru 4.
MANIFOLD 2 Press
ENTER
to accept this data.
:
MANIFOLD 4
SHAPE (distinguishes between underground and aboveground)
TANK SHAPE 1
HORIZONTAL
Use
UP/DOWN
▲
▼ keys to choose shape.
VERTICAL Press
ENTER
to accept this data.
(aboveground storage tank)
TYPE (select STANDARD 1 thru XX... see Appendix A)
TANK TYPE N
SPECIAL #
Use
UP/DOWN
▲
▼ keys to choose type.
Press
ENTER
to accept this data.
(for Standard Tank types, or SPECIAL 1 thru 8 or program
the special tank(s) under the SPECIAL TANK N menu )
PROBE
PROBE FOR TANK N
Use
UP/DOWN
▲
▼ keys to choose probe#.
PROBE #
Press
ENTER
to accept this data.
Select the correct Probe channel # for TANK N...
Any Probe # (input channel Number) can be used for any Tank.
For example, Probe 8 (the probe that is wired to probe input
channel #8) can be installed in Tank 1 ....BUT a Probe can not
be used (or programmed or assigned) to more than one
tank ! Assigning the same Probe #N to more than one Tank, will
display an alarm when exiting SETUP (to warn you that more
than one tank is referencing the same probe) ! The system will
remain in setup until this problem is fixed.
Set Probe data under the PROBE menu (Chpt. 3.)
PRODUCT
PRODUCT FOR TANK N
Use
UP/DOWN
▲
▼ keys to choose product#.
PRODUCT #
Press
ENTER
to accept this data.
(select Product 1 thru 8 ...
the PRODUCT menu is not
present if a Manifold is selected / changed from
NONE
) ...Also see PRODUCTS menu for standard
products and Special product programming.
NOTE
☞
To Next Page
Loading...
Need help?
General
