SCALD Tank Leak Test Setup Page 11 - 3
11
SCALD (tank leak) Test Menu (C
ONTINUED
....
FROM
PREVIOUS
PAGE
)
VAPOR RECOVERY (select ENABLED when Vapor Recovery is present)
SCALD VAPOR RECOVERY
DISABLED
Use
UP/DOWN
▲
▼ keys to show choices.
ENABLED Press
ENTER
to accept this data.
(Enable for vapor recovery systems)
ALARM ON (change to YES if you want an alarm when a SCALD
ALARM ON SCALD FAIL leak test fails)
NO
Use
UP/DOWN
▲
▼ keys to show choices.
YES Press
ENTER
to accept this data.
TST FL OG (
*
This menu appears only when ALARM ON SCALD
SCALD FAIL OUTPUT GROUP FAIL – YES was chosen above)
TANK 1
TANK 2 Press the (
M
) key to select a TANK #.
: Use
UP/DOWN
▲
▼ keys to show more choices.
TANK 8
SCALD TEST FAIL OUTPUT GROUP N (32 OGs available ...
see WORKSHEET # 8-1.)
NONE
Not assigned to an output group (OG).
GROUP A-FF One OG selected (A=1st OG, FF=32nd OG)
ALL GROUPS All OGs selected
Use
UP/DOWN
▲
▼ keys to show more choices.
Press
ENTER
to accept this data.
— Your Notes —
—
❖
—
To Next Page
Loading...
Need help?
General
