86 Description of the Menu
iina70e 06.fm technical handbook(1408)
6.8 Access Control
• Main Menu > Access Control
With this menu you can deny or allow access to specific functions of the UL1000 and
UL1000 Fab.
6.8.1 Access to CAL function
• Main Menu > Access Control > Access to CAL function
It can be selected whether the access to the calibration menu is restricted or not.
Fig. 6-23: The Access Control Menu
Softkey 2: Access to CAL function
Please refer to Chapter 6.8.1
Softkey 3 Access to Trigger&Alarme menu
Please refer to Chapter 6.8.2
Softkey 7: Change device-PIN
Please refer to Chapter 6.8.3
Softkey 8: Change Menu-PIN
Please refer to Chapter 6.8.4
Softkey 3: Off
The calibration function is only available at the main menu. If the Menu-PIN
(See Chapter 6.8.4) is activated you need this PIN to start a calibration.
Softkey 5: ?
Help
Softkey 7: ON
The calibration function is available at the main menu and in Stand-by and
the measure mode.
Softkey 8: OK
Save the settings and return to the previous menu.
To Next Page
Loading...
