56 Description of the Menu
iina70e 06.fm technical handbook(1408)
6.2.3 Time axis
• Main Menu > View > Time axis
The length of the time axis in trend mode can be changed in steps of 16 … 960 s.
6.2.4 Contrast
• Main Menu > View > Contrast
The contrast of the display can be changed. The changes are applied synchronously.
The recommended value under regular conditions is 50 (or close to it).
Tipp If by accident the display has been set too bright or too dark so that it can
not be read off, this may be changed as follows:
Switch off the UL1000 and UL1000 Fab and turn it on again. During the run-
up phase press the key no. 3 or 7 so long until the display can be read
properly again. This setting is saved to the EPROM only after confirming
this through the contrast menu. If this setting is not confirmed, the former
setting will be appled after switching on the instrument on again.
Softkey 3: Arrow down
Decrease the length of the time axis. The minimum time value is 16 seconds.
The time slice is extended during the measurement mode. (Up to max. 960 s) It is
displayed automatically during the AUTO mode.
Softkey 5: ?
Help
Softkey 7: Arrow up
Increase the length of the time axis. The maximum adjustable value is 960 seconds.
Softkey 3: Arrow down
Fade the contrast to dark. The minimum values is 0.
Softkey 4: Invert display
Invert the contrast of the screen.
Softkey 5: ?
Help
Softkey 7: Arrow up
Fade the contrast to light. The maximum value is 99.
To Next Page
Loading...
