50 tinb29e1-c (2019-10) VGC083A_B.om
This menu configures the display mode for the setup screen. The setup screen can
be configured to display the IG parameters in NORMAL or RESEARCH mode. Use
the UP and DOWN keys to select the desired setup screen mode from the
following menu choices.
• NORMAL Normal display mode for IG
• RESEARCH Research display mode for IG
Select "NORMAL" if you would like to configure the setup screen to display the IG
parameters in the normal mode shown below.
Select "RESEARCH" if you would like to configure the setup screen to display the
IG parameters in the research mode shown below. This is particularly helpful when
troubleshooting IG issues.
[Factory default = ON]
The VGC083 set-up screen uses an OLED type display which over an extended
period of time can start to show divergence between pixels that are on at all times
verses pixels that are not. This could result in pixels exhibiting a burned-in effect.
To minimize the burned-in effect, a screen saver function can be activated by pro-
gramming the SCREEN SAVER menu selection to ON. With the screen saver func-
tion turned on, the setup screen changes display appearance every 12 hours. The
display will appear in the normal mode with a dark background color for the first
12 hours and will then switch to a back-lit background color for the next 12 hours. If
you like to have the 12 hour period for the normal display mode to start at a specific
time of the day, simply access the SCREEN SAVER menu and change setting to
OFF and then ON again. This initiates the screen saver function immediately.
To increase longevity of the OLED display, INFICON recommends that the screen
saver function remains ON as shipped from the factory.
[Factory default = 0]
The BRIGHTNESS menu allows the user to select the brightness of the setup
screen display. The brightness setting of 0 provides the lowest brightness (con-
trast) and 10 the highest.
To increase longevity of the OLED display, INFICON recommends that the bright-
ness function remains at 0 as shipped from the factory.
[Factory default = 8]
Depending on the age of your controller this LED BRIGHTNESS menu may not be
available in your product. The LED BRIGHTNESS menu allows the user to select
the brightness of the three channel pressure measurement LED displays. The
brightness setting of 0 provides the lowest brightness (contrast) and 10 the highest.
To Next Page
Loading...
