Infinium CLEO - Configuration Management

User’s manual of CLEO Patient Monitor
- 14 -
is to display as you want.
SCREEN CALIBRATION
Calibrate the touch screen; the detailed operation is to see Factory Setup.
DEFAULT CONFIG
If the parameter settings are invalid, you can call the Default Config to recover the original
settings. The screen will display a menu to let you confirm the setup.
After returning to the above confirmation menu, a message of “Load Successfully!” will
display in the message highlight area, showing that the system has begun to work with
the new settings.
SAVE CONFIG
You can change monitor settings as required and then save the changed settings. The
screen will display a menu to let you confirm the setup:
After returning to the above confirmation menu, a message of “Save successfully!” will
display in the message highlight area, showing that the system and all monitoring
parameter settings have been saved (see each chapter).
[NOTE]
1. The module combination ‘EtCO
2
+ NIBP + QTemp’ exists only when the EtCO
2
module type is Internal.
2. The display mode will switch to ‘EtCO
2
+NIBP’ if the EtCO
2
module type changes
to External under the ‘EtCO
2
+ NIBP + QTemp’ display mode.
[NOTE]
Make sure that the changes are suitable for your patient.