User’s manual of CLEO Patient Monitor
- 15 -
HOW TO MONITOR
1. Depending on the parameter needed, connect the correlated sensors to the sockets
on the bottom of the panel;
2. Connect to the power supply, and press the power switch in the front panel;
3. Power indicator should light up, and the display screen will enter the main screen after
10 seconds;
4. Connect the detector with the patient;
5. Set monitoring parameters (see chapters below) ;
6. Enter the monitoring state.
[CAUTION]: Follow local government ordinances and recycle instructions regarding
disposal or recycling of device components, including batteries.
[CAUTION]: If the CLEO is to be stored for a period of 2 months or longer, notify service
personnel to remove the battery from the monitor prior to storage. Recharge the battery
when the battery has not been recharged for 2 or more months.
To Next Page
Loading...
