14
English
Installation
Powering the Projector On / Off
Powering On the Projector
1. Securely connect the power cord and signal cable. When
connected, the On/Standby LED will turn red.
2. Turn on the lamp by pressing the “ ” button either on the
remote control or the control panel. The On/Standby LED will
now ash blue.
1
The startup screen will display in approximately 10 seconds.
The rst time you use the projector, you will be asked to
select the preferred language and power saving mode.
3. Turn on and connect the source that you want to display
on the screen (computer, notebook, video player, etc). The
projector will detect the source automatically. If not, press the
“Menu” button and go to “OPTIONS”.
Make sure that the “Source Lock” has been set to “Off”.
If you connect multiple sources at the same time, press the
“Source” button on the control panel or direct source keys on
the remote control to switch between inputs.
Power
RG2
1
To Next Page
Loading...
Need help?
General
