15
English
Installation
Contact the
nearest service
center if the
projector displays
these symptoms.
See page
65 for more
information.
Powering off the projector
1. Press the “ ” button on the remote control or the control
panel to turn off the projector.
The following message will be displayed on the screen.
Press the “ ” button again to conrm otherwise the
message will disappear after 10 seconds. The projector will
shut down when the “ ” button is pressed for the second
time.
2. The fans will continue to operate for 10 seconds and the
On/Standby LED will ash blue. During this period, the
projector cannot be turned back on and the projector
should not be unplugged.
Once the cooling cycle is complete the On/Standby LED
will turn to solid red (standby mode). At this point, the
projector can be turned back on by pressing the “ ” button.
3. Disconnect the power cord from the electrical outlet and the
projector.
Warning Indicator
When the warning indicators (see below) come on, the
projector will automatically shutdown:
Lamp LED indicator is lit red and if the On/Standby LED
ashes red. This indicates the projector lamp has failed.
Temp LED indicator is lit red and if the On/Standby LED
ashes red. This indicates the projector has overheated.
Under normal conditions, the projector can be switched
back on.
Temp LED indicator ashes red and if the On/Standby
LED ashes red. This indicates a fan failure.
Unplug the power cord from the projector, wait for 30 seconds
and try again. If the warning indicators light up again, please
contact your nearest service center for assistance.
To Next Page
Loading...
Need help?
General
