38 Keypads
Anti-intrusion control panels
• access the “Keypad date/time” section on the user menu after entering a valid code.
1. Use keys and to select the programming field you wish to change (hour, minutes,
etc.).
2. Use keys and to change the selected field.
3. Press to save the setting.
6-6-8
Keypad settings
The keypads have a section for the programming of the displays and buzzers of the keypads
which access to the Prime system.
The parameters which are available depend on the type of keypad.
• Brightness - the intensity of the backlight of the display and key LEDs, when a key is
pressed and for the following 20 seconds.
• Standby brightness - the intensity of the backlight of the display and key LEDs when the
keypad is in stand-by status.
• Contrast - black/white contrast adjustment.
• Volume - intensity of buzzer loudness.
• Keypad options:
•• Temperature off - if enabled, the temperature value read by the built-in temperature
sensor will not be shown (only for temperature-sensor equipped keypads).
•• NoExitTimeSignal - if enabled, the buzzer will not emit an audible signal during
partition exit time.
•• NOEntryTimeSignal - if enabled, the buzzer will not emit an audible signal during
partition entry time.
•• Beep on output - if enabled, the buzzer will emit an audible signal during activation of
keypad terminal T1, when this is programmed as an output.
•• Disable Chime - if enabled, the buzzer will not emit an audible signal when a bell zone
is violated.
•• LED Off in standby - if enabled, this option switches of the relative LEDS after at least
40 seconds of inactivity on the keypad.
These settings apply only to the keypad you are working on, and will be saved even in the
event of panel shutdown.
The user can operate via the keypad in two ways:
• by activating the “Date/Time” shortcut (shortcut n.18), associated with one of the keys
, ..., shown on the display, with or without code entry
• access the “Keypad settings” section of the user menu by typing-in a valid code PIN.
1. Use keys and , followed by to select the parameters to be programmed.
2. Use keys and to increase or decrease the value of the selected parameter. To
activate the selected option press , to deactivate it press .
3. Press to save.
6-6-9
Change code PIN
To change user code PIN via keypad, the user can operate in two ways:
• activate the “Change PIN” shortcut (shortcut n.34 ), associated with one of the keys ,
..., shown on the display, with or without code entry
• access the “Change PIN” section of the user menu by typing-in the current code PIN.
1. Use keys and followed by OK to select the code to be changed.
2. Type-in the new PIN (4, 5 or 6 digits) using keys , ..., then press OK.
3. Type-in the new PIN again using keys , ..., and press OK to save.
Brightness
User Code
Outputs ON/OFF
Keypad date/time
Keypad settings
Keypad settings
Brightness
BrightnessStdby
Contrast
To Next Page
Loading...
