INIM Electronics Prime Series

User’s manual
Keypads 39
6-6-10
Edit telephone numbers
To change the telephone numbers from the keypad, access the user menu in the "Telephone
Numbers" section by entering your PIN code.
Access the phonebook:
1. Use keys and to select the required phone number then press OK; each pro-
gramming field accepts a 20 digit phone number.
2. Use keys and to select the field you wish to change, then use the number keys
( , etc.) to edit the number. The following characters are also accepted: “,” (= 2
second pause), “*” and “#”.
3. Press OK to confirm and exit.
6-6-11
Overtime request
The overtime request via keypad can be activated in two ways:
• activate the “Overtime” shortcut (shortcut n.8 ), associated with one of the keys , ...,
shown on the display, with or without code entry
• access the “Overtime req.” section of the user menu by typing in a valid code PIN.
6-6-12
Thermostat
The “thermostat” function can be controlled via keypad in two ways:
• activate the “Thermostat menu” shortcut (shortcut n.37 ), associated with one of the keys
, ..., shown on the display, with or without code entry
• access the “Thermostat” section of the user menu by typing-in a valid code PIN.
1. Use the number keys to select the operating mode of the thermostat:
• - thermostat Off
• - “Manual”
• - “Daily”
• - “Weekly”
• - “Antifreeze”
2. Select the operating mode (“Summer/Winter”) of the thermostat using .
3. Select the temperature, using keys and .
4. Select the timeframe, using and .
5. Select the day of the week, using and .
6. Press OK to confirm and exit.
6-6-13
Code Management
The user menu provides a section for the programming of the parameters of hierarchically-
lower user codes (refer to paragraph 3-1 User Codes).
The parameters which can be changed in this section are also available in other sub-sections.
Access the “Timers” section of the user menu by typing-in a valid code PIN.
1. Use keys and followed by OK to select the code to be changed.
2. Use keys and followed by OK to select the parameter to be changed.
3. Change the parameter then press OK to save the changes.
Table 6-17: Thermostat ON
Line Display View
1
operating mode of the thermostat and day of the week
2
pre-set temperature bar and “Summer/Winter” operating
mode icon
3 temperature setting and operating hours
4
temperature reading and the status of the heating system/air-
conditioning system (ON/OFF)
Off
User Code
Teleservice req.
Overtime request
Thermostat
Week Friday
25.0 c H18-19
18.5 c - OFF -
Week Friday
25.0 c H18-19
18.5 c - OFF -