User’s manual
Keypads 45
Via Graphic
maps
The visualization of the status and monitoring of the Prime system and its parts can also be
achieved through the graphic maps accessible through the “Maps” section contained in the
“Apps” section.
Refer to Chapter 10 , Graphic maps.
6-7-7
Outputs management
The Alien keypad allows you to activate/deactivate manually the outputs the code is enabled
to work on.
Access the “Commands” section, then select the required sub-section:
• “Home automation”, for access to the outputs of the home automation system, code entry
not required.
• “Intrusion”, for access to the outputs of the intrusion control system, code entry required.
The available outputs are listed in both sections.
The activatable outputs are associated with two buttons, ON for activation and OFF for
deactivation, and an icon which changes accordingly:
• - output activated
• - output deactivated
The high-power relay outputs and dimmer outputs have a scroll bar for the visualization of
their supplied power/current, together with the numerical value and power factor (cosij).
These values can be adjusted using the “+” and “-” buttons.
6-7-8
Change date and time
The Alien keypad has a section that allows you to set the date and time in accordance with the
selected format.
Access the “Settings” section, type-in a valid user code then access the “Date/Time - Change
PIN - Change Tel. Numbers” section.
Changes can be made using the left/right and up/down scroll buttons and confirmed by the
OK button.
6-7-9
Keypad settings
Access the “Settings” section, type-in a valid user code and then access the “Alien” section.
This section will allow you to view the firmware version of the keypad in use on the connected
control panel and change the parameter settings of the keypad you are working on.
The settings will be saved even in the event of control-panel shutdown.
• Transparency - for the adjustment of the transparency effect
• Brightness - for the adjustment of screen brightness when touched (duration 45 seconds)
• Stand-by brightness - for the adjustment of screen brightness when the keypad is in
stand-by status
• Volume buzzer - for buzzer loudness adjustment
• Volume voice - for speaker loudness adjustment
• Skin - for the selection of one of the skins available for the Alien keypad screen
• Delay photo. - waiting time before the automatic startup of the photoframe application
during stand-by status
• Photo int. - interval between the display of photos used by the photoframe application
Table 6-20: View Nexus status via Alien keypad
Line View
1
• Mobile network provider (on the left side)
• “--” means that the Nexus is connected to the BUS
• “C” means that data transfer is in progress
• data network technology (on the right side)
G, GPRS service
3G, UMTS service
H, HSPA service
2
GSM signal reception (value between 1 and 100)
3
balance, at the last operation (expressed in the local currency)
4
Presence of ongoing faults
To Next Page
Loading...
