Installation Manual
General information 13
Do not expose the circuits to damage by removing the modules unnecessarily from their housings.
3. When removing or handling the boards, hold the board edges only.
4. Do not touch the electronic components, the printed circuits or the metal parts of the connectors.
5. Do not hand the module to another person without first ensuring that you both have the same
electrostatic potential. This can be achieved by simply shaking hands.
6. Place the board on an anti-static surface or a conductor surface with the same potential.
Further information regarding procedures relating to safety when working with electronic devices can
be found in Directive IEC 60147-0F.
2.16.3 Setting up the system
In order to provide adequate protection and instructions for proper use, security professionals
(Installers and maintenance technicians) must be familiar with the operating procedure of this device.
Please read the instructions carefully before installing and/or servicing the system.
Before first power-up, be sure that the earth connection has been completed properly on the
respective terminal.
The recommended minimum wire cross section for the earth connection is 2.5 mm
2
, that is, unless
otherwise stated in accessory documentation.
2.16.4 Replacement and disposal of used devices
Replacement
When replacing used devices, disconnect the devices concerned then complete the connections of the
new devices in compliance with the instructions printed on the respective leaflets.
Contact your local municipal offices for information regarding the disposal of used electronic devices.
Disposal
Do not burn used electronic devices, or allow them to pollute the environment (countryside, rivers,
etc.). Electronic devices must be disposed of in a safe environment-friendly way. In order to avoid
short-circuits, take all the necessary precautions when removing used batteries. Contact your local
municipal offices for information regarding the disposal of batteries.
To Next Page
Loading...
Need help?
General
