INIM Electronics SmartLoop

To Next Page

To Previous Page

Installation Manual

20 Internal devices

Figure 10 - The SmartLoop/NET board location on the motherboard

Main Page

Table of Contents3
Application and Use5
Overview5
About the Smartloop Fire Alarm Panel Series7
Description of the Models7
In Order to Validate the IMQ-SISTEMI DI SICUREZZA Certification, and in Compliance with EN54-2 Regulations7
Features8
About the Software9
Addressees9
Documentation Supplied9
General Information9
Manual Details9
Operator Authorization-Access Levels9
Conventions10
Disclaimer10
Intellectual Property Rights10
Note to the Installer10
Recommendations10
Technical Support10
Testing the System10
Manufacturer's Name and Address11
Device Identifier12
Safety Laws12
Warranty12
Device Management14
Environmental Conditions14
Product Handling and Storage14
Unpacking the Device14
Internal Devices16
The Motherboard16
About Attachment Boards17
The Smartloop/2L Board18
The Smartloop/Net Board19
The Smartlan Board21
The Smartloop/Pstn Board22
Smartletusee/Led Module23
The Smartloop/Inout Board23
The Smartloop/Prn Module (for "/P" Models Only)24
The Smartletusee/Lcd and Smartletusee/Led Repeater Panels26
Technical Specifications27
Choosing the Mounting Location29
Installation29
Installation Flow, Guidelines and Testing29
Connecting the Smartloop/Led Module31
Connecting the Smartloop/Prn Printer Module32
About the Circuitry33
Connections33
Note to the Installer Regarding Wiring and Connection Compliancy33
Description of the Motherboard Terminals34
Loop Connections34
Connecting Devices to the Loop35
Loop Terminals35
NAC Outputs (Notification Application Circuit)36
Alarm Relay37
AUX Output37
AUX R Output37
Fault Relay37
Terminal (for Shutdown Signaling)37
Connecting Repeater Panels to the RS 485 Bus38
Connecting the Smartloop/Inout Board38
Connecting the Smartloopnet Module38
Batteries40
Connecting a Serial Printer40
Connecting a Smartlinklan Board Equipped Panel to a PC40
Connecting to a PC or Serial Printer40
Connecting the Thermal Probe41
Connecting to the Mains Power Source (Electrical Switchboard)42
Powering up the System44
Testing Wiring Integrity44
LOOP Fault47
NAC, Alarm and Fault Output Trouble47
Troubleshooting47
Battery Fault48
Repeater Fault48
NET Link ALARM-A49
Smartloopnet Fault49
Appendix A Maintenance50
Appendix B Argus Devices Supported by the Control Panel51
- Apollo Devices Supported by the Control Panel55

INIM Electronics SmartLoop

Table of Contents

Other manuals for INIM Electronics SmartLoop

Related product manuals