INIM Electronics SmartLoop

Installation Manual
4
7.9 AUX output 37
7.10 AUX R output 37
7.11 Alarm relay 37
7.12 Fault relay 37
7.13 Connecting Repeater panels to the RS 485 bus 38
7.14 Connecting the SmartLoopNET module 38
7.15 Connecting the SmartLoop/INOUT Board 38
7.16 Connecting to a PC or serial printer 40
7.17 Connecting a SmartLinkLAN board equipped panel to a PC 40
7.18 Connecting a serial printer 40
7.19 Batteries 40
7.20 Connecting the Thermal Probe 41
7.21 Connecting to the Mains power source (Electrical Switchboard) 42
Chapter 8 Powering up the system....................................................... 44
8.1 Testing wiring integrity 44
Chapter 9 Troubleshooting..................................................................47
9.1 NAC, Alarm and Fault output trouble 47
9.2 LOOP Fault 47
9.3 Repeater Fault 48
9.4 Battery Fault 48
9.5 SmartLoopNET Fault 49
9.6 NET Link ALARM-A 49
Appendix A Maintenance ......................................................................50
Appendix B Argus devices supported by the control panel .........................51
Apollo devices supported by the control panel......................... 55
Appendix C Order Codes.......................................................................61
Installer’s notes .................................................................................62