Unpacking and Transportation
‑59‑
It is recommended that the lifting angle be above 45 degrees and that the relief
height not exceed 0.3 m.
Figure 3‑13 Lifting the T1 to T9 models
2. Slowly roll up the lifting rope with a crane until the rope is tight, and then lift the AC
drive.
3. Slowly lower the load and suspend it after it descends to a certain height. Then
slowly place the AC drive on the floor or mounting surface, and install it in the
control cabinet.
T10 to T12 models
Lifting steps for T10 to T12 models:
1. Hook the lift fitting parts at the top and bottom of the AC drive, take out the AC
drive from the packing box, and lay it flat on the floor.
Ensure that there is no stress on the positive and negative bus terminals.
To Next Page
Loading...
