Mechanical Installation (T10 to T12 Models)
‑107‑
Figure 5‑5 Top view of the cabinet for T11 and T12 models
To install T11 to T12 models into the nine‑fold profile cabinet with the depth of 600
mm, bend the back mounting board inwards (not required for the cabinet with the
depth of 800 mm), as shown in "
Figure 5–6
"
on page 107
. However, if the cabinet
with the depth of 600 mm has both front and back doors, the AC drive cannot be
installed in this kind of cabinet. Instead, install the AC drive into the cabinet with
the depth of 800 mm.
Figure 5‑6 3D of the cabinet for T11 and T12 models
2. Fix the bottom mounting bracket in the nine‑fold profile cabinet.
Fix the mounting bracket to the base of the nine‑fold profile cabinet by using six M5
self‑tapping screws, as shown in "
Figure 5–7
"
on page 107
.
Figure 5‑7 Installing the bottom mounting bracket
To Next Page
Loading...
