Mechanical Installation (T10 to T12 Models)
‑108‑
Drill holes for the mounting bracket and assemble the bracket on site if the cabinet is not a
nine‑fold profile one.
3. Assemble the guide rails (model: MD500‑AZJ‑A3T10) and mount the guide rail as‑
sembly to the cabinet.
a. Assemble the guide rail, as shown in "
Figure 5–8
"
on page 108
.
Figure 5‑8 Assembling guide rails
b. Align the two round holes at the front end of the mounting rail with the screws
of the mounting bracket, and then lock the guide rail to the cabinet with two M6
nuts, as shown in "
Figure 5–9
"
on page 108
.
Figure 5‑9 Mounting the guide rails to the cabinet
4. Remove the cover from the AC drive.
For details, see "
5.5.1 Removing the Cover
"
on page 111
. After the cover is removed,
the auxiliary handle will be exposed.
5. Align the casters of the AC drive with the guide rails and gently push the AC drive in‑
to the cabinet.
During the push‑in or pull‑out process, use the auxiliary strap to prevent the drive
from toppling over. It is recommended that two people work together.
To Next Page
Loading...
