Electrical Installation
‑168‑
Figure 8‑49 Requirements on tubular terminals of the control circuit cable
Table 8–17 Control circuit cable specifications
Single Cable mm² (AWG) Twisted Cable mm² (AWG)
Tightening Torque (N•m)
0.2 to 0.75 (24AWG to
18AWG)
0.75 mm 0.565
Wiring for connecting an external operating panel
To use an external operating panel, connect one end of the connecting cable to the
RJ45 port of the AC drive, and lead the other end of the cable from either side of the
AC drive, as shown in "
Figure 8–50 Wiring for connecting an external operating panel
"
on page 168
.
Figure 8‑50 Wiring for connecting an external operating panel
STO wiring example
● Wiring example when the external 24 V is used
To Next Page
Loading...
