ASSIST PLUS – Operating instructions V02 Operation
www.integra-biosciences.com 17
4 Operation
4.1 Turn on/off the ASSIST PLUS device
Connect ASSIST PLUS to the power supply with the supplied mains adapter. Turn on
ASSIST PLUS using the Main switch (11).
Press the Start/Pause key (17
) when it is blinking to home the ASSIST PLUS.
W
ARNING
Remove hands from ASSIST PLUS during homing.
After homing the LED of the Start/Pause key will turn off.
To switch ASSIST PLUS to standby press the On/Standby key (19
) for two seconds until
its LED dims. The ASSIST PLUS automatically switches in standby program after 2 hours
of inactivity. Press the On/Standby key again to return in active program.
Use the Main switch to turn off the instrument.
4.2 Turn on/off an INTEGRA electronic pipette
Press and release the Run key (30) to turn on the pipette.
To turn off the pipette, press and hold the Back button (25
) for 3 seconds.
4.3 Connection ASSIST PLUS to Pipette
4.3.1 Bluetooth connection
If the connection fails, press to retry the connection or refer to “4.5 Troubleshooting” on
page 19. Alternatively, continue Offline . In offline program you cannot run programs but
you can view and edit them. Active height teaching is not possible in offline program.
Select the ASSIST PLUS program in the Main Menu of the INTEGRA
pipette and press OK. The pipette establishes the Bluetooth
connection.
When the blue Bluetooth symbol ( ) next to the battery indicator is
displayed and the Communication LED (18
) lights up in blue, both
instruments are connected.
To Next Page
Loading...
