Installation 23
Operation Instruction
Introduction
This section of the handbook describes how to set up your Satellite TV System
after installation using the ACU or PC controller program and includes the
following functions:
System start up.
Changing the default satellite.
Monitoring the antenna status.
Setting sleep mode.
Entering setup mode.
Setting the satellite pair.
Editing satellite information.
Setting the antenna parameter.
Setting the LNB local frequency.
Setting GPS.
Setting the DiSEqC method.
Display versions.
Display power status.
Setting antenna go position.
Setting antenna move step.
Setting remote control.
Setting the factory default parameters.
Performing diagnostic tests.
Note: Many of the above functions will only be required at initial installation of your
system.
To Next Page
Loading...
