54 i3/i4 Satellite Antenna System – Install and User Manual
Set Satellite Information
DiSEqC using method
Satellite Verification method
Register satellite for tracking
Select LNB type
Set local f requency o f LNB
[XY Z
Satellite name and longitude
Select Triple Satellite
y Satellite Information
The name, longitude and confirmation method of the satellite is
displayed when a satellite is selected in the list box. Push “Edit
Satellite Information” button to update the information on
modifying the value.
y DiSEqC
When the operation method of DiSEqC is selected to “Change
Band”, DiSEqC may be used for updating the local frequency and
to “Change Satellite”, for updating the target satellite.
y Registration of target satellite
In case that the DiSEqC is selected to “Not Use” or “Change
Band”, only X“Register for Sat A” and Y“Register for Sat B” may
be registered. Pushing X or Y button after selecting the satellite
in the list box makes it possible to register A or B. In case that
DiSEqC is selected to “Change Satellite”, Z“Register for Sat A”
and [“Register for Sat B” are activated and the target satellite
when DiSEqC is available may be registered by pushing Z and [
buttons.
y Local Frequency
In case that DiSEqC is selected to “Change Band”, be sure to
push the “Universal LNB” button. In case that the DiSEqC is
selected to “Not Use” or “Change Satellite”, be sure to push
“Single Band” button and key in into the Local Frequency, and
then push “ Set Local Frequency” button.
To Next Page
Loading...
Need help?
General
