60 i3/i4 Satellite Antenna System – Install and User Manual
y Find Angles & Skew Antenna GPS – Finds the current antenna
angles and Skew angle in relation to the longitude of satellite and
GPS.
y Find Angles & Skew City GPS – Finds the current city angles and
Skew angle in relation to the latitude of satellite and GPS.
Set Tracking Information of Satellite [Primary]
Satellite to be edited
Power supplying method
Satellite inf ormation for Vertical & Low band
DiSEqC using method
Satellite inf ormation f or Horizontla & Lo w band
Satellite inf ormation for Vertical & High band
Satellite inf ormation f or Horizontal & High band
Command Button
y Edit Satellite Information – To change frequency information of
the antenna
y Satellite Information – Satellite information consists of frequency,
symbol and NID(Network ID) of a transponder in tracking satellite.
There are four groups of satellite information. ‘Vertical/RHCP’ is
applied when IRD supply 13V, and ‘Horizontal/LHCP’ is applied
when IRD supply 18V. ‘LOW’ is applied when DiSEqC signal is not
detected from IRD, ‘HIGH’ is applied when DiSEqC signal is
detected from IRD. If you select ‘Not Use’ or ‘Change Satellite’,
two ‘HIGH’ groups are inactivated. If you select Change Band’,
two ‘High’ groups are activated and you can modify satellite
information which is applied when DiSEqC signal is detected from
IRD. After modifying information, press ‘Edit Satellite Information’
button, then new information is updated in the antenna.
To Next Page
Loading...
Need help?
General
