D-0120794-C – 2019/11
Orion Rotary Chair Installation Instructions Page 19
OKN Drum and Cable mounted to Ceiling
The OKN Drum is controlled through a cable that goes between the booth ceiling and the chair base.
Connect one end of the OKN cable to the round CPC connector on the interconnect box on booth ceiling.
Make sure to thread the cable through the wire tie to provide cable restraint.
The thin grey cable from the booth ceiling should be fished through the same wire tie cable restraint. This
cable will be connected to the Intercom base unit in Section 5.2.
To Next Page
Loading...
